Metal Roof Panels
 

Metal Wall Panels
 

Trim Specialties
 

Distribution Materials
 


 
   R-Panel


   
 
  • Rugged design for commerical and industrial applications
  • Can be used as roof or wall panel
  • 15 colors to choose from (special colors available) in 26 gauge only
  • Available in 36" width for quick and easy installation
 
Technical Data
Roof Flashing Details
Wall Flashing Details
Finish Warranty
Color Chart
 
 

Product Overview
The R-Panel can be used for either a roof or wall application. With the R-Panel's long spanning capability it provides maximum load and span capacities.

Materials
36 " O.C.
24, 26 ga.

Requirements
Open Framing, Solid Substrate
Solid Substrate requires 30# Felt or Ice & Water Shield
High Side Attachment (6 fasteners per panel)
Sidelap Attachment ( 6 fasteners per panel, 1/2" x 3/32" Tape Sealant )
Intermediate Purlin Attachment (3 fasteners per panel)
Eave Attachment (6 fasteners per panel)
Minimum Roof Pitch: 1" on 12"

Finish
24 ga Kynar 500
26 ga Siliconized Polyester

  LEED Credits

LEED
If applicable Metal Roofing Systems, Inc. can provide LEED Information when requested. For information on state and local tax initiatives, please go to USGBC Government Resources page.

LEED: SS Credit 7.2 Heat Island Effect: Roof
Requirement: Roofing materials having a Solar Reflectance Index (SRI) equal to or greater than the values below for a minimum of 75% of the roof surface.

Low-Sloped Roof (<=2:12): SRI must be >= 78% (2 colors available)
Steep-Sloped Roof (>=2:12): SRI must be >= 29% (29 or more colors available)

LEED: MR Credit 4.1 Recycled Content
Our material contains the following recycled content:

Galvanized Steel: Recycled scrap represents some 31% of the finished product.
23% of this is Post-Consumer
8% of this is Pre-Consumer

Aluminum Products: Recycled scrap represents some 88% of the finished product.
35% of this is Post-Consumer
53% of this is Pre-Consumer

LEED: MR Credit 5.1 Regional Materials
To qualify the materials being used on the building must have been extracted, havested, or recovered, as well as manufactured, within 500 miles of the project site for a minimum of 10% of the total materials value.

Please contact Metal Roofing Systems to find out if your project will qualify for this LEED credit.

 

 
     
     



 
 
© 2013 Metal Roofing Systems