Metal Roof Panels
 

Metal Wall Panels
 

Trim Specialties
 

Distribution Materials
 


 
   MRS Flush Seam


   
 
  • Available in vented or solid profiles
  • Can be used as a wall or soffit panel system
  • Formed in 12",16" and 20" widths using 24 gauge steel or .032 aluminum
 
Technical Data
Wall Flashing Details
Finish Warranty
Watertightness Warranty
Color Chart
 
 

Materials
12", 16" and 20" widths
1/2", 1", 1 1/2" or 3/8" Slim-Line depth
24 ga, .032 aluminum

Features

  • Vented or Solid Profiles
  • Vent placement and widths can vary within panel limits
  • With or Without Stiffening Beads
  • Used as a wall panel or soffit panel system

Requirements
Open Framing, Solid Substrate
Solid substrate requires 30# Felt or Ice and Water Shield

Finish
Kynar 500® or Hylar 5000®
Two-Coat Fluropolymer (BASF)

  LEED Credits

LEED
If applicable Metal Roofing Systems, Inc. can provide LEED Information when requested. For information on state and local tax initiatives, please go to USGBC Government Resources page.

LEED: SS Credit 7.2 Heat Island Effect: Roof
Requirement: Roofing materials having a Solar Reflectance Index (SRI) equal to or greater than the values below for a minimum of 75% of the roof surface.

Low-Sloped Roof (<=2:12): SRI must be >= 78% (2 colors available)
Steep-Sloped Roof (>=2:12): SRI must be >= 29% (29 or more colors available)

LEED: MR Credit 4.1 Recycled Content
Our material contains the following recycled content:

Galvanized Steel: Recycled scrap represents some 31% of the finished product.
23% of this is Post-Consumer
8% of this is Pre-Consumer

Aluminum Products: Recycled scrap represents some 88% of the finished product.
35% of this is Post-Consumer
53% of this is Pre-Consumer

LEED: MR Credit 5.1 Regional Materials
To qualify the materials being used on the building must have been extracted, havested, or recovered, as well as manufactured, within 500 miles of the project site for a minimum of 10% of the total materials value.

Please contact Metal Roofing Systems to find out if your project will qualify for this LEED credit.

 

 
     

     



 

 
© 2013 Metal Roofing Systems